justyoumarket 
Nowadays, there are so many products of pipe heating cable 6 foot in the market and you are wondering to choose a best one. You have searched for pipe heating cable 6 foot in many merchants, compared about products prices & reviews before deciding to buy them.
You are in RIGHT PLACE.
Here are some of best sellings pipe heating cable 6 foot which we would like to recommend with high customer review ratings to guide you on quality & popularity of each items.
HEATIT HISD 6-feet Pipe Heating Cable with with Built-in Thermostat, Black
- Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two year limited quality . If you are not completely satisfied with HEATIT heating cable, please don’t hesitate to contact our customer service in any time, we’ll try our best to solve your issues.
- Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 68F on39F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid.
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket.
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight.
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off.
- Copper
Frost King HC6A 6 Feet Automatic Electric Heat Cable Kits, Black
M-D Building Products 4325 M-D 0 Pipe Heating Cable, 6 Ft L
- This item is a M-D Building Products 4325 6-Foot Pipe Heating Cable with Thermostat
- Purpose of use for Rough Plumbing, pipe-heat-cables
- This product is manufactured in China
- Prevents frozen water pipes to -50°F
- Easy to install just “wrap around” application
- Sensor light shows thermostat is working
- Available in 6 different lengths
- Built in thermostat
This M-D Building Products 6-Foot Pipe Heating Cable with Thermostat is UL- and CSA-approved and designed to prevent water line freeze up. Ready to install, grounded cord and plug, thermostat controlled, with pilot light. Recommended for use on metal and rigid plastic pipes. Exclusive Press-To-Test button test cable before installing! The built-in thermostat turns cable on at 38 Degree F. Reliable low wattage design uses up to 70% less energy than other cables and protects to -50 Degree F! Wrap around not needed.
HEATIT JHSF 6-feet 120V Self Regulating Pre-assembled Pipe Heating Cable
- JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com).
- Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional.
- Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather.
- ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. Four year limited warranty. If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue
Similar items with 4 stars and above
HEATIT JHSF1-CT Self Regulating Pre-assembled Pipe Heating Cable 6-feet 120V
- HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com). Suitable for use on plastic and metal water pipes( including inlet pipe,drain pipe, sewer, palm tree frost protection etc). Industrial grade self regulating heating cable. The cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional.ETL approved.
- Fluoropolymer (Industrial grade: One of the most heavy duty plastic material) as the outer jacket. JHSF1-CT cables are configured for use in nonhazardous and hazardous locations, including areas where corrosives may be present. Exposure to organic chemicals or corrosives. Can be used underwater application. Please keep the connection (Meet water proof IP65) between the orange cold lead and black heating cable above the water level. The black heating cable including end seal meet water proof IP68
- Protect pipes up to 2 1/2″ in diameter. For a better freeze protection, at least 1/2 inch thick or thicker insulation material is recommended, especially for extremely cold weather. If the ambient temperature is lower than -20°F(-29°C), please use 1″ thick insulation material. Pre-assembled, Including grounded plug with light, easy to install install and use without built in thermostat. 120 volt, 5 watts/ft at 50 degrees F for pipe freeze protection. 6ft 18/3 cold lead with grounded plug.
- Roof deicing application: Can be used on flat roofs, metal roofs, asphalt roofs, rubber roofs, slate roofs, stone roofs, metal roofs, ceramic roofs, composite (tar and gravel) roofs and so on. Rated 10W/ft at 32°F (0°C) for roof deicing. For roof deicing application, you may need to buy clips and hangers separately.
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable Normally you can feel the slight warm on the heating cable in few minutes. Ten year limited warranty – If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue.
Similar items with 4 stars and above
GardenHOME Pipe and Valve (6Feet) Heat Tape Cables, Black
- SECURED PROTECTION, protects pipes from 6-8 feet (1.83-2.44 m) and up to 1-1 1/2 inches (25.4-38.1 mm) in diameter – 2 Pack
- EASY INSTALLATION, just put our Icebreaker cable along the pipes to keep ice and coldness away (Recommended for use on water-filled metal and rigid plastic pipes). Grounded cord and plug.
- ENERGY SAVING, THERMOSTAT CONTROLLED, the built-in thermostat can sense the temperature of the pipe. It turns the cable on at 38°F and turns it off automatically when the pipe has been heated to a temperature of approximately 45°F.
- ECONOMICAL, reliable low wattage design saves up to 70% energy than other cables and protects your cable to -50°F.
- DURABLE, weather resistant PVC outer jacket and inner insulation. It will operate for years without requiring maintenance.
Description Say goodbye to frozen pipes in the winter with the GardenHome Pipe Heating Cable – 6 ft. (1.83 m). This temperature-controlled cable runs along pipes and valves, thawing frozen pipes. The built-in thermostat will sense the temperature of the pipe and turn the cable on and off to provide the most economical solution for frozen pipe disasters. How it Works Before applying the heating cable, make sure that the area on and around the pipe is clear and that the heating cable is warm and pliable. Simply plug the cable into the nearest grounded electrical receptacle, secure the thermostat tightly against the pipe with electrical tape, secure the heating cable straight along the pipe, and let the heating cable work its magic. The built-in thermostat will automatically detect the temperature of the pipe and turn the cable on when exposed to temperatures below 38F for frost-free pipes all winter long. It will shut the heating cable off when the pipe has been heated to a temperature of approximately 45F, incurring no extra electricity costs.
Similar items with 4 stars and above
9milelake Cold Weather Pipe and Valve Heating Cable with Built-in Thermostat (6 Feet)
- Pre-assembled for easy installation,Easy Heat pipe heating cable installs quickly and easily to keep
- Includes grounded plug, built in thermostat, and instructions,
- Each cable consists of tough PVC inner insulation, a continuous ground braid, and weather-resistant
- units are activated and de-activated by an integral energy-saving thermostat
- Approved for rigid plastic and metal pipe
Description Say goodbye to frozen pipes in the winter with the 9milelake Pipe Heating Cable – Lenghth Option: 3ft,6ft,9ft,12ft,18ft,24ft,30,40ft .
This temperature-controlled cable runs along pipes and valves, thawing frozen pipes.
The built-in thermostat will sense the temperature of the pipe and turn the cable on and off to provide the most economical solution for frozen pipe disasters.
Use only on water-filled metal & plastic pipes.
How it Works Before applying the heating cable, make sure that the area on and around the pipe is clear and that the heating cable is warm and pliable.
Simply secure the thermostat tightly against the pipe with electrical tape, secure the heating cable straight along the pipe, plug the cable into the nearest grounded electrical receptacle, and let the heating cable work its magic.
The built-in thermostat will automatically detect the temperature of the pipe and turn the cable on when exposed to temperatures below 38°F (3°C) for frost-free pipes all winter long.
It will shut the heating cable off when the pipe has been heated to a temperature of approximately 45°F, incurring no extra electricity costs. What’s Included Package includes cable with grounded plug and built in thermostat, user-friendly instructions
Wrap-On SEPTLS34731006 – Pipe Heating Cables
Product Description
Prevents frozen water pipes to –50F. Simply wrap on, insulate and plug in. Engineered for use on metal and rigid plastic pipes. Uses an exclusive Press-To-Test button so you can test the cable before installing. A built-in thermostat turns the cable on at 38F. Proven low-wattage design uses up to 65 percent less energy at 2 watts a foot vs. other cables at 7 watts a foot, and protects to –50F. An exclusive power sensor light glows when the thermostat is closed. Each package contains one ready-to-install pipe heating cable along with installation instructions. To install, you will also need PVC/electrical tape, fiberglass pipe insulation, a tape measure and eye protection. Warning: This cable has been designed for the sole purpose of preventing metal and rigid plastic water filled lines from freezing. DO NOT use this product on fuel lines, drain lines, hoses or buried pipes. Fiberglass pipe wrap is required to complete the installation. Read and follow all instructions. Cables are available in various lengths. See chart to determine the length required for your application.
From the Manufacturer
Pipe Heating Cable – 31006 6-Foot Ul Pipe Heating Cable
Conclusion
By our suggestions above, we hope that you can found pipe heating cable 6 foot for you.Please don’t forget to share your experience by comment in this post. Thank you!
